Search for: All records

Secondary organic aerosol (SOA) accounts for a large fraction of submicron particles in the atmosphere. SOA can occur in amorphous solid or semi-solid phase states depending on chemical composition, relative humidity (RH), and temperature. The phase transition between amorphous solid and semi-solid states occurs at the glass transition temperature (T_g). We have recently developed a method to estimate T_g of pure compounds containing carbon, hydrogen, and oxygen atoms (CHO compounds) with molar mass less than 450 g mol⁻¹ based on their molar mass and atomic O : C ratio. In this study, we refine and extend this method for CH and CHO compounds with molar mass up to ∼ 1100 g mol⁻¹ using the number of carbon, hydrogen, and oxygen atoms. We predict viscosity from the T_g-scaled Arrhenius plot of fragility (viscosity vs. T_g∕T) as a function of the fragility parameter D. We compiled D values of organic compounds from the literature and found that D approaches a lower limit of ∼ 10 (±1.7) as the molar mass increases. We estimated the viscosity of α-pinene and isoprene SOA as a function of RH by accounting for the hygroscopic growth of SOA and applying the Gordon–Taylor mixing rule, reproducing previously published experimental measurements very well. Sensitivity studies were conducted to evaluate impacts of T_g, D, the hygroscopicity parameter (κ), and the Gordon–Taylor constant on viscosity predictions. The viscosity of toluene SOA was predicted using the elemental composition obtained by high-resolution mass spectrometry (HRMS), resulting in a good agreement with the measured viscosity. We also estimated the viscosity of biomass burning particles using the chemical composition measured by HRMS with two different ionization techniques: electrospray ionization (ESI) and atmospheric pressure photoionization (APPI). Due to differences in detected organic compounds and signal intensity, predicted viscosities at low RH based on ESI and APPI measurements differ by 2–5 orders of magnitude. Complementary measurements of viscosity and chemical composition are desired to further constrain RH-dependent viscosity in future studies. 

Abstract. Information on liquid–liquid phase separation (LLPS) and viscosity (ordiffusion) within secondary organic aerosol (SOA) is needed to improvepredictions of particle size, mass, reactivity, and cloud nucleatingproperties in the atmosphere. Here we report on LLPS and viscosities withinSOA generated by the photooxidation of diesel fuel vapors. Diesel fuelcontains a wide range of volatile organic compounds, and SOA generated bythe photooxidation of diesel fuel vapors may be a good proxy for SOA fromanthropogenic emissions. In our experiments, LLPS occurred over the relativehumidity (RH) range of ∼70 % to ∼100 %,resulting in an organic-rich outer phase and a water-rich inner phase. Theseresults may have implications for predicting the cloud nucleating propertiesof anthropogenic SOA since the presence of an organic-rich outer phase athigh-RH values can lower the supersaturation with respect to water requiredfor cloud droplet formation. At ≤10 % RH, the viscosity was ≥1×108 Pa s, which corresponds to roughly the viscosity of tarpitch. At 38 %–50 % RH, the viscosity was in the range of 1×108 to 3×105 Pa s. These measured viscosities areconsistent with predictions based on oxygen to carbon elemental ratio (O:C)and molar mass as well as predictions based on the number of carbon,hydrogen, and oxygen atoms. Based on the measured viscosities and theStokes–Einstein relation, at ≤10 % RH diffusion coefficients oforganics within diesel fuel SOA is ≤5.4×10-17 cm2 s−1 and the mixing time of organics within 200 nm diesel fuel SOAparticles (τmixing) is 50 h. These small diffusion coefficientsand large mixing times may be important in laboratory experiments, where SOAis often generated and studied using low-RH conditions and on timescales ofminutes to hours. At 38 %–50 % RH, the calculated organic diffusioncoefficients are in the range of 5.4×10-17 to 1.8×10-13 cm2 s−1 and calculated τmixing values arein the range of ∼0.01 h to ∼50 h. These valuesprovide important constraints for the physicochemical properties ofanthropogenic SOA.